PIPE PLUGS INTRODUCTION

 

	Stopping flow in a pipeline for maintenance or repair down stream
	Pipeline acceptance testing, or to stop flow so infiltration of a section can be measured
	Diverting flow around a work area or to isolate flows in a line with several incoming lateral lines
	Flood control to prevent rising ocean or river water from entering an outfall
	Reducing the entry of toxic gases into the work area

These products are available in a variety of styles, sizes, and configurations so as to match your specific job requirements. The product you select will be provided to you Contractor Ready, meaning that the people, in the field, using this equipment, get the equipment ready to use. The proper selection and application of these products can be an important aspect of insuring a safe and productive work environment.

 

MECHANICAL PIPE PLUGS

Mechanical Pipe Plugs are designed for use in concrete, clay, and some plastic pipe. Some advantages would include:

	Requires no air/good for long term applications
	Standard single sizes from ½" to 21"
	Larger sizes available

 

PNEUMATIC DISK PIPE PLUGS

Pneumatic Disk Pipe Plugs are designed for use in concrete, clay, and some plastic and steel pipe. Some advantages would include:

	Slim profile / bolt together sections
	Higher back / test pressure capabilities than other low pressure plugs
	Standard single sizes from 4" to 96"
	Other sizes and shapes available

 

SINGLE SIZE PNEUMATIC ALL RUBBER PIPE PLUGS

 

Single Size Pneumatic All Rubber Pipe Plugs are designed for use in a wide variety of pipe types and styles. Some advantages would include:

	Will seal most slightly out of round pipes
	Standard sizes from 1 ½" to 48"
	Economical when only one pipe size is needed.